Quick Start Guide

Quick start guide

Thank you for choosing the Illumina Face Mask! Follow these instructions to start your journey.
  1. Set Up the Mask

    Connect the power cord to the mask. Attach the upper straps (UL and UR). Optionally, attach the lower straps (LL and LR) to adjust the mask fit closer to the face.

  2. Prepare Your Skin

    Cleanse your face with RENEW Hydrating Foam Cleanser and follow with RENEW Calming Facial Spray. Place the mask on your face and lightly tighten the straps for a snug but comfortable fit. Adjust the upper straps if needed to relieve pressure.

  3. Power On and Select Mode

    Press and hold the Power button to turn on the mask. The mask will automatically enter P1 mode. Press the Power button again to switch to P2 mode, and a third time to enter P3 mode.

  4. Start or Pause a Session

    Once your mode is selected, press the Start/Pause button to begin a 10-minute session. The indicator light will turn on. To pause, press the Start/Pause button, and the indicator will flash. Press again to resume. If no action is taken after 30 seconds, the mask will turn off automatically.

  5. Session Duration and Frequency

    Each session lasts for 10 minutes. Use the Illumina Face Mask 3-5 times per week for optimal results. If you need to switch modes during a session, pause the session first, then repeat steps 1-4.

NOTE: Refer to the Illumina Face Mask User Guide that comes with your device for complete instructions for use, warnings, and precautions.