Quick Start Guide

sculpt belt against black background sculpt belt against black background sculpt belt against black background sculpt belt against black background

Quick start guide

Thank you for choosing the iRESTORE Sculpt LED Belt! Follow these simple steps to begin your first session.

  1. Prep

    Choose your treatment area. Common areas include the waist, lower back, shoulders, and legs. Clean and dry your skin before use — the device works best on bare, clean skin for optimal light absorption.

  2. Power Up

    Connect the included USB-C adapter to the belt, then plug the adapter into a wall outlet. Alternatively, connect to the iRESTORE Universal Power Bank (sold separately).

  3. Wrap

    Secure the belt snugly around your chosen treatment area so the LEDs are in direct contact with — or hovering just above — the skin. Avoid over-tightening.

  4. Start Your Session

    Press and hold the Power button for 2 seconds to begin treatment. The default session will start at Level 3 (100% brightness) for 10 minutes.

  5. Adjust Brightness (Optional)

    Short-press the Level button to cycle through brightness settings:

    • Level 3 = 100% brightness (default)
    • Level 2 = 75% brightness
    • Level 1 = 50% brightness
    💡 Tip:

    If this is your first time, we recommend starting at Level 1 (50%) for 10 minutes, then gradually increasing brightness and duration as your skin adjusts.

  6. Adjust Timer (Optional)

    Short-press the Timer button to select your session length:

    • 10 Min (default)
    • 20 Min
    • 30 Min

  7. Relax

    Relax and keep the belt in place for the duration of your session. The Sculpt LED Belt will automatically shut off and emit a beep when your session is complete.

  8. Manual Power Off (Anytime)

    Press and hold the Power button for 2 seconds to end your session early.

Charging the Sculpt LED Belt

  1. Connect the included USB-C adapter to the charging port on the belt's control panel, then plug into a wall outlet.
  2. Charge until the indicator lights are solid, showing a full charge.
  3. Recharge every 3 months if not in regular use to preserve battery health.
  4. The device can also be used while connected to power — simply plug in and begin your session.

Getting the Most from Your Sessions

  • Always use on clean, dry skin — no lotions or creams before treatment
  • For new users, start with Level 1 and 10-minute sessions for the first week
  • Allow the device to cool between consecutive sessions to avoid automatic shutoff
  • Do not stare directly at the LEDs during use
  • Store rolled (not folded) in the original packaging to protect the light panel